Application
	The electric water level gauge is used for rapid and reliable measurement of water levels in wells, observation tubes and narrow boreholes.The measuring value can directly be read on the measuring cable. Fast changing in water levels (pumping test) can be measured continuously.
	Description
	If the feeler of the sensor (zero point) of the water level gauge is touching the water surface the signal lamp on the cable drum will switch on. Faulty measurements are not possible as the contact of the lamp can only be made by touching the water surface. By raising and lowering the cable a very short distance whereupon the lamp goes off and on again the exact water level can be determined.The measuring depth can directly be read on the cable in m and cm.
	Water level gauge KLL15-50 Water level gauge KLL80-300
	Technical data
	Type KLL15 KLL30 KLL50 KLL80 KLL100 KLL150 KLL200 KLL300 Cable length 15m 30m 50m 80m 100m 150m 200m 300m Cable High resistant to extension 2-wire flat cable, with black cm- and red m-scale of high precision Cable drum Hand drum for cable lengths of 15 to 50 m Cable drum with free standing support for cable lengths of 80 to 300 m Probe Ø 15mm, length approx. 190mm, with corrosion resistant electrode Electronic Fully transistorised, no consumption of power when not using the instrument Power supply Batteries 6V (4x battery LR14, baby cell)
	Downloads
	Adobe Acrobat Document(*.pdf)